When you want to deploy the connector initially, you may want to install the filter driver or not. Below are the values you can use to achieve this:
/NORESTART – This will avoid a restart, which is normally the case when installing the agent above versions 6.0.3, but is normally a good idea just in case.
/SILENT – to install without prompting
/VERYSILENT – this will suppress any pop-ups, and for remote installs, or packaged installs this is likely the option you want.
If a restart is necessary and the ‘/NORESTART’ command isn’t used (see below) and Setup is silent, it will display a Reboot now? message box. If it’s very silent it will reboot without asking.
/TYPE=full or compact – for full install or compact to not install the filter driver – you can also elect to not enter a type, and you will get the installation without the change tracking filter driver.
/LOG=”logfile.log” – the name and location of where you would like the install log stored. Use full path if required i.e. C:\TEMP\Logfile.log
/SUPPRESSMSGBOXES – Instructs Setup to suppress message boxes. Only has an effect when combined with ‘/SILENT’ or ‘/VERYSILENT’.
So the actual command line would like the following if you wanted the filter driver installed:
connector-win32.exe /SUPPRESSMSGBOXES /NORESTART /VERYSILENT /TYPE=full /LOG="Actifio_agent_install.log"
or if you don’t want the filter driver running (such as inside a VMware Virtual Machine) run the following:
connector-win32.exe /SUPPRESSMSGBOXES /NORESTART /VERYSILENT /LOG="Actifio_agent_install.log"
And for Uninstall you can either goto Add/Remove Programs and choose to uninstall the Actifio Connector, or run the following commands:
1. Open a command prompt and go to C:\Program Files\Actifio\
2. Run the command:
unins000.exe /SILENT
You should be good to go now.